Tire Mould Release Agents is water based semi-permanent release agent which contains special active polysiloxane. It can form a thin, uniform coating film on the surface of the mould, which can reduce the adhesion between the rubber and the mould, prevent rubber vulcanizates from sticking to the molds and facilitate the release from the molds, and thereby improve the quality of product appearance; Tire Mould Release Agents product can give a release effect for several demoldings and also reduce the cleaning frequency of the mould.  

At the first time, the mould should be clean before using Tire Mould Release Agents, and then spray Tire Mould Release Agents two or three times onto the hot mould carefully. After that, a short drying / curing time is necessary to accelerate the film formation, longer drying time and higher curing temperature will get an durable release film and effective performance with more demoulding times. Normal vulcanization process can be performed if the pretreatment above were completed. The latter vulcanization process just need spray Tire Mould Release Agents one time in certain intervals and dry for a short time.

The number of demoldings that can be achieved with one coat is very much dependent on the particular conditions and has to be investigated in every single application. It is advisable to apply Tire Mould Release Agents on to the surface of the mold by means of a spray gun.

Mould Release Agents can be used in the production process of all kinds of rubber except Silicone rubber. It is suitable for all articles that are formed by injection molding or compression molding.

Tire Mould Release Agents is water based semi-permanent release agent which contains special active polysiloxane. It can form a thin, uniform coating film on the surface of the mould, which can reduce the adhesion between the rubber and the mould, prevent rubber vulcanizates from sticking to the molds and facilitate the release from the molds, and thereby improve the quality of product appearance; Tire Mould Release Agents product can give a release effect for several demoldings and also reduce the cleaning frequency of the mould.  

At the first time, the mould should be clean before using Tire Mould Release Agents, and then spray Tire Mould Release Agents two or three times onto the hot mould carefully. After that, a short drying / curing time is necessary to accelerate the film formation, longer drying time and higher curing temperature will get an durable release film and effective performance with more demoulding times. Normal vulcanization process can be performed if the pretreatment above were completed. The latter vulcanization process just need spray Tire Mould Release Agents one time in certain intervals and dry for a short time.

The number of demoldings that can be achieved with one coat is very much dependent on the particular conditions and has to be investigated in every single application. It is advisable to apply Tire Mould Release Agents on to the surface of the mold by means of a spray gun.

Mould Release Agents can be used in the production process of all kinds of rubber except Silicone rubber. It is suitable for all articles that are formed by injection molding or compression molding.